Zone card

Show and control the lights, energy or climate of a room or floor.

On this page

One card for one thing about a room or floor: its lights, its energy use or its climate. Add a card for each one you want to see, and place them apart.

Settings

Setting What it does
Zone The Homey zone the card is about
Lights, Energy or Climate What this card shows and controls
Show title Show or hide the title
Title The card's heading. Leave it empty to use the zone's name

Lights, energy or climate

Type Shows Control
Lights Lights that are on, out of all the lights in the zone Tap the card to switch the zone. If any light is on they all go off, otherwise they all go on
Energy The current power use of every device that measures its own, added together None, it only shows
Climate The average temperature and humidity, and the target temperature − and + change the target temperature of every thermostat in the zone

A socket set up as a light in Homey counts as a light. Devices that cannot be controlled, such as a sensor-only thermostat, are shown but left alone.

Zones inside zones

A zone includes everything nested below it. Pick a room to see that room, pick a floor to see all of its rooms, or pick your home to see the whole house. The controls follow the same rule: a Lights card for a floor switches every room on that floor.

Which card should I use?

  • Zone when you think in rooms: turn the living room off, see what the kitchen is using, set the bedroom a little warmer.
  • Multicard when you want to see and control several specific devices one by one.
  • Thermostat when you want a proper dial for a single thermostat.
  • Gauge when one number matters and you want it against a range.

What it does not count

  • Estimated power. Only devices that actually measure their power are added up. A lamp whose usage Homey merely estimates adds nothing, so the figure can be lower than the one in Homey's own Energy screen.
  • Whole-home meters, solar panels and home batteries. A meter already includes every other device, and panels and batteries are not usage, so adding them would make the total meaningless.
  • Unavailable devices. Their last known values may be out of date, so they are left out until they come back.

The climate values are plain averages. A fridge or boiler sensor placed in the zone pulls the average with it, so move that device to its own zone in Homey if the number looks wrong. When thermostats in a zone are set differently, the card shows their average, and − or + gives them all the same new target.

Tips

  • On-tap behaviour. Setting an on-tap action in the Advanced tab replaces the controls: a Lights card then opens a dashboard or runs a flow instead of switching, and a Climate card loses its buttons. Needs confirmation and a PIN code apply to the controls too.
  • A PIN is not access control. It guards the dashboard, not the devices.
  • Tidy your zones first. The card is only as accurate as the zones in Homey. A device in the wrong zone is counted, and switched, in the wrong place.
Something unclear or out of date? Let us know or ask in the Discord community.